|Place of Conferral||北京|
|Keyword||铁铜锰复合氧化物 吸附 砷 壳聚糖 颗粒化|
1. 采用氧化还原/共沉淀法制备了铁铜锰复合氧化物，该吸附材料是由许多纳米级粒子团聚而成，为无定型结构，具有较大的比表面积（162.3 m2/g）。铁铜锰复合氧化物对As(Ⅲ)和As(Ⅴ)都具有良好的吸附效果，在溶液pH为7.0时，对As(Ⅲ)和As(Ⅴ)的最大吸附容量分别为131.3 mg/g和105.4 mg/g，吸附效果优于其他文献中报道的粉末吸附剂。铁铜锰复合氧化物在较广泛pH范围（3.0 ~ 9.0）内对As(Ⅲ)和As(Ⅴ)均具有良好的吸附效果。而且该吸附材料具有良好的再生性能，用氢氧化钠溶液处理使吸附的砷有效脱附，可多次重复使用。
3. 以壳聚糖为黏合剂，采用滴加成球法制备了颗粒状铁铜锰复合氧化物吸附剂。颗粒状铁铜锰复合氧化物对As(Ⅲ)和As(Ⅴ)也具有出良好的吸附性能，在pH为7.0时，最大吸附容量分别达到56.5 mg/g和24.0 mg/g。颗粒状铁铜锰复合氧化物吸附材料也具有良好的再生性能，可多次重复使用。利用颗粒状铁铜锰复合氧化物进行连续动态吸附柱实验。当水力停留时间为10 min，As(Ⅲ)初始浓度为259.4 μg/L时，吸附柱达到穿透（即出水口砷浓度达到10 μg/L）时，可处理5200个柱体积的模拟含As(Ⅲ)地下水。As(Ⅴ)初始浓度为260.4 μg/L时，吸附柱达到穿透时，可处理3500个柱体积的模拟含As(Ⅴ)地下水。
Arsenic, a ubiquitous element in the environment, is well known and extensively concerned with high toxicity. It is generally introduced into the water and groundwater through natural processes and some human activities, which poses a significant threat to human health. Arsenic pollution has become one of the urgent environmental problems and attracted attention of researchers all over the world.
In natural water environments, arsenic exists in two predominant species, arsenate [As(Ⅴ)] and arsenite [As(Ⅲ)]. As(Ⅲ) is much more soluble, toxic, mobile and more difficult to remove than As(Ⅴ). Compared with other treatment techniques for arsenic removal, adsorption is regarded as one of the most promising methods due to its simple operation, low cost and reusability. However, most reported adsorbents are difficult to remove As(Ⅲ) and As(Ⅴ) from water simultaneously over a wide pH range. Therefore, it is of great significance to develop new, efficient and widely applied adsorbents for arsenic removal.
In this research, a novel Fe-Cu-Mn trimetal oxide adsorbent was developed aiming at simultaneously effectively removing both As(Ⅲ) and As(Ⅴ), which combined the high adsorption capacity of iron oxide and copper oxide to As(Ⅴ) and oxidation performance of manganese oxide to As(Ⅲ). Moreover, the granular Fe-Cu-Mn trimetal oxide (GFCM) was fabricated using chitosan as adhesive to expand its application range. This adsorbent was well characterized with various techniques and its arsenic adsorption performance and removal mechanisms were investigated. The following results were obtained.
1. The Fe-Cu-Mn trimetal oxide adsorbent was synthesized via a facile one-step oxidation-coprecipitation method. The synthetic Fe-Cu-Mn trimetal oxide was composed of many aggregated nanograins with amorphous structure and a high BET surface area (162.3 m2/g). The synthetic Fe-Cu-Mn trimetal oxide adsorbent had high adsorption capacities of As(Ⅲ) and As(Ⅴ), especially As (Ⅲ). At pH 7.0, the maximum adsorption capacities of As(Ⅲ) and As(Ⅴ) on Fe-Cu-Mn trimetal oxide adsorbent were 131.3 mg/g and 105.4 mg/g, respectively, which were better than that of adsorbents reported in other literatures. The synthetic Fe-Cu-Mn trimetal oxide adsorbent had good adsorption effect on As(Ⅲ) and As(Ⅴ) over a wide range of pH (3.0 ~ 9.0). The Fe-Cu-Mn trimetal oxide was well regeneratable and the adsorbed arsenic can be desorbed with NaOH solution and reused again.
2. As(Ⅴ) was removed by ion exchange, forming inner-sphere complex on surface of the adsorbent. The removal mechanism of As(Ⅲ) is an oxidation coupled with adsorption approach. Mn oxide in adsorbent is mainly responsible for As(Ⅲ) oxidation, while Fe and Cu oxides are dominant for adsorbing arsenic. Moreover, Cu oxide contributes to enhance arsenic adsorption performance of the Fe-Cu-Mn trimetal oxide over a wide pH range.
3. A novel adsorbent of granular Fe-Cu-Mn trimetal oxide (GFCM) was fabricated by using chitosan as adhesive. The GFCM was effective for both As(Ⅲ) and As(Ⅴ)adsorption. At pH 7.0, the maximal adsorption capacities were 56.5 and 24.0 mg/g, respectively. The granular Fe-Cu-Mn trimetal oxide was well regeneratable. The GFCM can be easily used in the flow-through system. The experimental results of column tests demonstrated that about 5200 and 3500 bed volumes of simulated groundwater containing 259.4 μg/L As(Ⅲ) and 260.4 μg/L As(Ⅴ) were respectively treated before breakthrough (10 μg/L).
|王建燕. 铁铜锰复合氧化物的制备、颗粒化及其对砷吸附性能研究[D]. 北京. 中国科学院大学,2019.|
|Files in This Item:|
|王建燕-最终版.pdf（1422KB）||学位论文||开放获取||CC BY-NC-SA||Application Full Text|
|Recommend this item|
|Export to Endnote|
|Similar articles in Google Scholar|
|Similar articles in Baidu academic|
|Similar articles in Bing Scholar|